Zigbee Wireless Technology Trainer Model

Order Code: 10941

Category: Consumer Electronics Trainers

Features: Trainer offers comprehensive experiment set up explaining Bluetooth & Zigbee Protocols. Either my buy shared set up with replaceable NICs or independent setup of nodes for each technology.  owever NICs could be replaced&nbs...



SPECIFICATION

Features:
  • Trainer offers comprehensive experiment set up explaining Bluetooth & Zigbee Protocols.
  • Either my buy shared set up with replaceable NICs or independent setup of nodes for each technology.  owever NICs could be replaced in one setup to experiment with other.
  • Table top setup made using light but sturdy Aluminum profile (4X2) Rack.
  • Lab PC with serial / USB port required for network monitoring or ot work as user, PC not in scope of supply.
  • Set of Users Guides provided with each unit.

 

Technical Specification 

  • Operating Frequency Band ISM 2.4GHz
  • Indoor/Urban : Up to 133`(400m)
  • Outdoor line-of- sight : up to 400`(120m)
  • Transmit Power : 2mW ( 3dBm)
  • Receiver Sensitivity: 95dBmRF Fata Rate:250,000bps
  • TX Current: 40mA(@3.3V)
  • RX Current : 40mA (@3.3V)
  • Power
  • Each direct sequence channel has over 65,000 unique network addresses available Point to-Point, Point or multipoint and peer to- peer topologies supported Self Routing, self -healing And fault-tolerant mesh networking
  • RSSI Indication on LED

Nodes

4 embedded Nodes with 4 replaceable NICs for each technology kept under transparent cover.

Node Hardware

A) Embedded Controller device: 89C668 operating @ 16MHz. On chip RAM: 8KB, Flash/EEPROM:64KB. B) Serial port (RS232C) 9pin D (M). C) In built USB to serial converter. D) Display: 20X4LED (Backlit). E) General Purpose SMD bicolor (green, red) 8X2LEDs &8 SMD push button switches/DIP switches. F) Power (SMPS): 5V/2.5Amp SMPS with RCA plug. SMPS.ACI/P230Vac+/-10%/50Hz X 4Nos.

Node Software

Mbedded program written in C for Bluetooth & Zigbee protocol

Network Interface card

Bluetooth application module mounted on adaptor PCB 4 Nos

PC Software

Network Monitor

Experiment topics Software

/Configuring Master & Slave. Data exchange from one device to other. Select device name & transmit key, led status messages to be observed LED.

Mech.

Dimension/Wt.

900mm(L) X 300mm (W) X 720mm (H) / 20kg

Enquiry Form