Voltage to Current Converter (V to I) with power supply and 2 meters (C.R.)

Order Code: 36264

Category: Analog Electronics Trainers

Experimental Training Board has been designed specifically to study Voltage to Current Converter using OP-AMP ICs 741. This Training Board gives a deep understanding of the conversion of voltage into proportional current in both Inverting & ...



SPECIFICATION

Experimental Training Board has been designed specifically to study Voltage to Current Converter using OP-AMP ICs 741. This Training Board gives a deep understanding of the conversion of voltage into proportional current in both Inverting & Non-Inverting configurations. The board is absolutely self contained and requires no other apparatus.
Practical experience on this board carries great educative value for Science and Engineering Students.

Object
To Study the conversion of input voltage into proportional current irrespective of load for Inverting & Non-Inverting modes.

Features:
The Board consists of the following built-in parts:
01. ± 15V D.C. at 50mA, IC regulated power supply internally connected.
02. 0 - 5V D.C. at 50mA, continuously variable power supply.
03. Two OP-AMP ICs 741.
04. D.C. Milliammeter, 65mm rectangular dial with switch selectable ranges of 1mA and 5mA.
05. D.C. Voltmeter, 65mm rectangular dial to read 0-5V.
06. Adequate no. of Electronic Components.
07. Mains ON/OFF switch, Fuse and Jewel light.
* The unit is operative on 230V ±10% at 50Hz A.C. Mains.
* Adequate no. of patch cords stackable from rear both ends 4 mm spring loaded plug length ½ metre.
* Good Quality, reliable terminal/sockets are provided at appropriate places on panel for connections & observation of waveforms.
* Strongly supported by detailed Operating Instructions, giving details of Object, Theory, Design procedures, Report Suggestions and Book References.

Enquiry Form