Vector Signal (Spectral) Analyzer

Order Code: 22235521.1.23

Category: General Lab Equipment I

Free on-site installation, training and compliance demonstration shall be vendor’s responsibility. Technical Parameter: Detailed Specifications Operational, programming and service manual (Electronic form) must be provided with the ins...



SPECIFICATION

Free on-site installation, training and compliance demonstration shall be vendor’s responsibility.

Technical Parameter:

Detailed Specifications

Operational, programming and service manual (Electronic form) must be provided with the instrument.
Frequency Range : 10 Hz to 50 GHz

 
Sweep Span : 0 Hz (Zero Span), 10 Hz to maximum frequency

 
Frequency Counter Resolution: 0.01 Hz

 
Frequency Reference Ageing Rate: ± 3x10-8/Year

 
Pre-Amplifier: 100 KHz to 50 GHz

 
Resolution Bandwidth: 1 Hz to ≥ 8 MHz

 
Video Bandwidth: 1 Hz to ≥ 8 MHz

 
Analysis Bandwidth: ≥ 500 MHz

 
Attenuator: 0 to 70 dB (min)

 
Maximum Safe Input CW RF Power: +30 dBm

 
Displayed Average Noise Level (DANL) Pre-Amplifier off Pre-Amplifier on

  • 150 dBm@2GHz, -145 dBm@20GHz, -132 dBm@50GHz
  • 162 dBm@2GHz, -160 dBm@20GHz, -145 dBm@50GHz

 
Phase Noise

  • 132 dBc/Hz@10 kHz offset from 1GHz carrier
  • 110 dBc/Hz@10KHz offset from 40 GHz carrier

 
Third Order Intercept Point (TOI)

  • Better than +8 dBm

 
Required Vector Signal -Analysis Measurement
Application Capabilities:
Based on the description of signal to be analyzed (e.g. Modulation format, Continuous or with burst, Symbol rate, transmit filtering etc), following signal analysis measurement capabilities are required: · Vector Signal Analysis Bandwidth: 500 MHz· Magnitude Error, Phase Error, Frequency Error, SNR, Spectrum .Magnitude vs time, IQ vs time, EVM (Error Vector Magnitude), IQ Analysis,Spectrogram, Eye Diagram.

 
Supported Modulation types for Vector Signal Analysis:

  1. FSK, MSK, GMSK, DMSK
  2. BPSK, QPSK, Offset-QPSK, DQPSK, 8PSK, and 16 & 32 APSK (DVB-S2)
  3. Up to 1024 QAM
  4. AM, PM, FM
  5. User-Definable Modulation Constellation & Mappings

 
RF Input Connector: 2.4 mm with saver, 50 Ohms (Nominal)

 
Interfaces : LAN, USB

 
Other Ports:

  1. External Reference Input Required
  2. Reference Output: 10 MHz

 
Operating Temperature Range: 10 deg. C to 40 deg. C

 
Power Requirement: 

  1. 230 V AC, 50 Hz (Nominal)
  2. Power Cord with 3-pin plug (Indian type)

 
Measurement Capabilities:

  1. Analog Modulation Analysis
  2. Noise Figure Measurement Application
  3. Phase Noise Measurement Application
  4. Spurious Measurements
  5. Harmonic Measurement
  6. Vector Signal Analysis

Enquiry Form