Phasing Calibration Machine

Order Code: 18193404.2.2

Category: General Lab Equipment III

1. Feature  Total common rail test equipment consists of two units; injector tester and pump tester  Tests all types of injectors, high pressure pumps, and common rail simultaneously tests injectors and pump due to the respective po...



SPECIFICATION

1. Feature 

  • Total common rail test equipment consists of two units; injector tester and pump tester 
  • Tests all types of injectors, high pressure pumps, and common rail simultaneously tests injectors and pump due to the respective power supply 
  • The testing machine could be testing widely using car in local. (English using UI) 

2. Specification 
A. Injector test unit 

  • Checks 4 injectors at the same time 
  • Test applicable to Bosch, Delphi, Denso, Siemens, Delphi Euro 5, and Piezo 
  • Measures injection and leakage quantity 
  • Tests injectors in low/medium/high pressure and pilot 
  • Monitors injection pattern 
  • Variable voltage control 
  • Tests injectors for heavy commercial vehicle below 25t 
  • Temperature performance due to automatic cooling system 
  • Power supply Single phase AC220V/380V, 1/5(2HP) 4P inverter installed 
  • Dimension(mm)/weight 1400(L)×860(D)×1630(H)/420kg 
  • Working pressure(Bar) 120 ~ 1850 Bar 
  • Main injection 100~1200 

B. Pump test unit 

  1. Test applicable to Bosch (CP1, CP3), Delphi, Denso 
  2. Tests pump below 5t 
  3. Measures pump output, discharge rate of valve (IMV, MP-ROP) Measures leakage quantity 
  4. Tests high pressure maintenance power for each section 
  5. Easy to repair pump with being installed on the stand 
  6. Power supply Single phase AC220V/380V, 1/5(2HP) 4P 
  7. Working pressure(Bar) 100 ~ 2500 Bar (according to pump) Duty range According to pulse inside (by 1) 
  8. DRV range 0 ~ 100% (by 0.5%) 
  9. 5. Free defect maintenance 
  10. Minimum 2 years of free maintenance is guaranteed in case of any defect found. 

3. Standard Accessories 

  • English User Manual 5 copies 
  • Dust cover 

4. Installation and Inspection 

  • Equipment should be installed in a designated place and time specified by user. 
  • Inspection should be done after equipment training. 

Enquiry Form