Op-Amp Applications with power supply and 1 meters

Order Code: 36247

Category: Analog Electronics Trainers

Experimental Training Board has been designed specifically for the study of different OP-AMP applications. Practical experience on this board carries great educative value for Science and Engineering Students. Object: To study the following OP-A...



SPECIFICATION

Experimental Training Board has been designed specifically for the study of different OP-AMP applications.
Practical experience on this board carries great educative value for Science and Engineering Students.

Object:
To study the following OP-AMP applications:
  1. Square Wave generator.
  2. Pulse & Ramp generator.
  3. Triangular Generator.
  4. Sine Wave Generator using Wien Bridge, Phase Shift Network.
  5. Active Filters :
    • Low Pass Filter.
    • High Pass Filter.
    • Band Pass Filter.
    • Notch Filter.
  6. Voltage Regulators.
  7. Null Detector.
  8. D.C. Microammeter.

Features:
The board consists of the following built-in parts
  1. ±15V D.C at 25mA, IC Regulated Power Supply.
  2. 0-20V D.C at 100mA, continuously variable Power Supply.
  3. D.C. Milliammeter, 65mm rectangular dial to read 0-1mA.
  4. Two OP-AMP IC's 741.
  5. Three Linear Potentiometers.
  6. Two Zener Diodes and adequate no. of other electronic components
  7. Mains ON/OFF switch, Fuse and Jewel light.
  8. The unit is operative on 230V ±10% at 50Hz A.C. Mains.
  9. Adequate no. of patch cords stackable from rear both ends 4mm spring loaded plug length ½ metre.
  10. Good Quality, reliable terminal/sockets are provided at appropriate places on panel for connections / observation of waveforms.
  11. Strongly supported by detailed Operating Instructions, giving details of Object, Theory, Design procedures, Report Suggestions and Book References.

Other Apparatus Required:
  1. Digital Multimeter 3¾ digit
  2. Audio Frequency Generator
  3. A.C. Millivoltmeter
  4. Cathode Ray Oscilloscope 20MHz

Enquiry Form