ISDN -Trainer

Order Code: 20213544.1

Category: General Lab Equipment II

Specifications: Hexagon DSP v56 core up to 850MHz, 768KB L2 cache, MEMORY 16GB eMMC + 2GB LPDDR3(default), 32GB eMMC + 4GB LPDDR 3 (optional), Operating System Android OS 7.1 Power Supply DC power supply : 4.75V~6.0V (typical: 5....



SPECIFICATION

Specifications:

  • Hexagon DSP v56 core up to 850MHz, 768KB L2 cache,
  • MEMORY 16GB eMMC + 2GB LPDDR3(default), 32GB eMMC + 4GB LPDDR 3 (optional),
  • Operating System Android OS 7.1

Power Supply

  • DC power supply : 4.75V~6.0V (typical: 5.0V)
  • VBAT : 3.55V~4.4V (typical: 3.8V)

LCM Interfaces

  • Two 5-inch 1280 × 720 HD resolution LCD

Touch Panel Interfaces

  • One capacitive touch panel

Camera Interfaces

  • Rear camera supports 16M pixels
  • Front camera supports 8M pixels

USB Interface

  • USB type-C interface, Compliant with USB 3.0 and 2.0 specifications, with transmission rates up to 5Gbps on USB 3.0 and 480Mbps on USB 2.0, Support USB OTG,
  • Used for data transmission, software debugging and firmware upgrade

Audio Interfaces

  • Analog Input: 3 groups of analog microphone inputs, integrating internal bias voltage
  • One headset input
  • One ECM-type microphone input
  • One MEMS-type microphone input
  • Analog Output : 3 groups of analog audio outputs, including
  • One stereo headset output
  • One mono earphone differential output

(U)SIM Interfaces

  • Support USIM/SIM cards: 1.8V and 2.95V,
  • Support dual SIM dual standb

UART Interfaces

  • Main UART for data transmission and AT command communication Debug UART for debugging

SD Card Interface

  • Support 4-bit SD card with hot-plug detection, MIPI+SPI/I2S Interface Reserved

Antenna Interfaces

  • main antenna • Rx-diversity/MIMO antenna • GNSS antenna • Wi-Fi/BT antenna

Flashlights

  • Support 2 flashlight LEDs for testing the module's flashlight interfaces

Sensors

  • Support three sensors including ALS/PS, accelerometer/gyroscope and compass

Vibrator

  • A vibrator for testing the motor drive interface of the module

Switches and Buttons

  • 4 switches including two power supply switches ,one emergency, download switch and one USB switch; 4 buttons including RESET (reserved), PWRKEY, VOL_UP and VOL_DOWN;

Status Indication LEDs

  • 3 LEDs are available for signal indication

 

Enquiry Form