Function Generator

Order Code: 2223839.7.19

Category: General Lab Equipment I

Outputs square wave, sine wave, triangle wave, TTL pulse, positive and negative ramp, pulse and skewed sine wave, AM, and sweep functions Frequency Ranges 0.1 Hz to 11 MHz, up/down range switchable in eight decade steps Dial Range 1 to 11 calibr...



SPECIFICATION

  • Outputs square wave, sine wave, triangle wave, TTL pulse, positive and negative ramp, pulse and skewed sine wave, AM, and sweep functions
  • Frequency Ranges 0.1 Hz to 11 MHz, up/down range switchable in eight decade steps Dial Range 1 to 11 calibrated 0.1 to 1 uncalibrated Dial Accuracy ±5% of full scale from 0.1 Hz to 10 MHz 11 MHz setting not less than 11 MHz (ambient temperature 20° C to 30° C) 
  • Pulse and Ramp Frequency 1/10 of dial frequency Pulse and Ramp Aspect Ratio 95:5 
  • Main Output Amplitude Two ranges: 0-20 Vp-p 200 mV to 20 Vp-p (open circuit) 100 mV to 10 Vp-p (50 ohm load) 0-0.2 Vp-p 20 mV to 2 Vp-p (open circuit) 10 mV to 1 Vp-p (50 ohm load) 
  • Main Output Impedance 50 ohm ±10%
  • DC Offset <-10 V to >+10 V (open circuit) <-5 V to >+5 V (into 50 ohm load) 
  • Amplitude Flatness(At 10 kHz, 50 ohm Load) Within ±0.5 dB, 0.1Hz to 110kHz Within ±1.5 dB, to 1.1 MHz, Within ±2.5 dB, to 11 Mhz 
  • Sine Wave Distortion <1% from 10 Hz to 100 kHz -30 dB at all other frequencies (ambient temperature 20° C to 30° C) 
  • Triangle Wave Linearity 0.1 Hz to 100 Hz >or= 99%, 100 kHz to 1 MHz >or= 97% Measured from 10% to 90% of waveform 
  • Square Wave Transition Time <or= 25 ns rise/fall time at maximum output into a 50ohm load
  • Square Wave Aberrations <or=4% peak-to-peak at maximum output into a 50 ohm load Sync TTL Output Rise/Fall Time <25 ns into 50 ohm
  • load VCF (FM) Input A ±10 V signal input shifts frequency >or= 1000:1 up or down with dial set at 0.1 or 11 respectively 
  • External Gate Input >or= +2 V gate signal required, not to exceed +15 V fixed 0 degree start phase
  • Internal Sweep Rate Continuously variable from 0.5 to 50 Hz
  • Internal Sweep Width Variable from 1:1 to 100:1

Enquiry Form