Firing circuit using Op-Amps and Gates with Power Supply

Order Code: 46540

Category: Electrical Machine Lab

Power Electronic Training Board has been designed specifically for the study of the firing circuit for single-phase converter using Op-Amps and Gates. Practical experience on this board carries great educative value for Science and Engineering ...



SPECIFICATION

Power Electronic Training Board has been designed specifically for the study of the firing circuit for single-phase converter using Op-Amps and Gates.
Practical experience on this board carries great educative value for Science and Engineering Students.

Object:
To study firing circuit for single-phase converter using Op-Amps and Gates.

Features:
The board consists of the following built-in parts:
01. 6VAC at 100mA, AC Power Supply.
02. ±12V DC at 100mA fixed regulated Power Supply.
03. Eight Op-Amp’s IC,
04. Quad 2 input AND gate IC.
05. Two NPN Transistors.
06. Two Pulse Transformers 1:1.
07. Three Potentiometers.
08. Adequate no. of other Electronic Components.
09. Mains ON/OFF switch, Fuse and Jewel light.
* The unit is operative on 230V ±10% at 50Hz A.C. Mains.
* Adequate no. of patch cords stackable 4 mm spring loaded plug length ½ meter.
* Good Quality, reliable terminal/sockets are provided at appropriate places on panel for connections/ observation of waveforms.
* Strongly supported by detailed Operating Instructions, giving details of Object, Theory, Design procedures, Report Suggestions and Book References.

Enquiry Form