Fibre Optics Communication Trainer With PC Communication Facility

Order Code: 28526A

Category: Fiber Optic Trainers

Order Code -28526A is a single board Fiber Optic Trainer  to study the characteristics of Fiber using Digital and Analog techniques. This kit also facilitates with digital and analog Modulation & Demodulation communication tec...



SPECIFICATION

Order Code -28526A is a single board Fiber Optic Trainer  to study the characteristics of Fiber using Digital and Analog techniques. This kit also facilitates with digital and analog Modulation & Demodulation communication techniques.

SPECIFICATIONS:

  • Two Transmitter Fiber Optics LED having peak wavelength of emission 660nm & 950nm.
  • Two Receiver Fiber Optic photo detector.
  • Modulation & Demodulation Techniques using Direct AM, FM, PPM, PWM.
  • On-board Analog & Digital Drivers.
  • On-board AC Amplifiers.
  • On-board PLL Detector
  • Analog Band Width 350 Khz.
  • Digital Band Width 2.5 Khz.
  • 4th order Butter worth 3.4KHz Low Pass Filter.
  • On-board 1Hz. To 10 KHz sine wave (amplitude adjustable),
  • Square wave (TTL)
  • FO voice link using microphone & speaker
  • RS-232C PC to PC Serial link using 9 Pin D -type.
  • Four Switched Faults for transmitter & receiver.
  • Fiber Optics Cable Connector type Standard SMA .
  • Duly polished fiber at both end for Numerical Aperture Measurement.
  • Step indexed multimode PMMA plastic cable.
  • Core Refractive Index 1.492.
  • Clad Refractive Index 1.406.
  • Numerical aperture Better than 0.5.
  • Acceptance Angle Better than 60o
  • Fiber Diameter 1000 microns.
  • Outer Diameter 2.2mm.
  • Fiber Length 5m & 1m.
  • In-Built Power Supply 5V/1.5A, ±12V/250mA.
  • Interconnections 2 mm Banana Sockets
  • User's Manual with set of Patch Chords.
  • 230mm x 140mm x 80mm (L x W x H)

Enquiry Form