Fiber Optic Transmission Training System

Order Code: 23247255.1

Category: General Lab Equipment IV

Scope of learning : Setting up Fiber Optic Analog Link Setting up Fiber Optic Digital Link Study of Intensity Modulation Technique using Analog Input Signal Study of Intensity Modulation Technique using Digital Input Signal Setting up of ...



SPECIFICATION

Scope of learning :

  • Setting up Fiber Optic Analog Link Setting up Fiber Optic Digital Link
  • Study of Intensity Modulation Technique using Analog Input Signal
  • Study of Intensity Modulation Technique using Digital Input Signal
  • Setting up of Propagation Loss in Fiber Optic Study of Bending Loss.
  • Measurement of Optical Power using Optical Power Meter
  • Measurement of Propagation loss using Optical Power Meter
  • Measurement of Numerical Aperture Characteristics of F-O Converter using OPM
  • Characteristics of Fiber Optic communication Link
  • Setting up of Fiber Voice Link using Intensity Mode
  • Study of PC to PC Communication using Fiber Optics Digital Link
  • Frequency Modulation and Demodulation
  • PWM Modulation and Demodulation

Technical specifications :

  • Two Transmitter Fiber Optics LED having peak wavelength of emission 660nm & 950nm
  • Two Receiver Fiber Optic photo detector
  • On-board Analog & Digital Drivers.
  • On-board AC Amplifiers.
  • Analog Band Width 350 Khz
  • Digital Band Width 2.5 Khz
  • 4 order Butter worth 3.4KHz Low Pass Filter
  • On-board 10Hz. To 10 KHz sine wave (amplitude adjustable), square wave Selectable.
  • FO voice link using microphone & speaker
  • RS-232C PC to PC Serial Link using 9 pin D-Connector.
  • Fiber Optics Cable Connector type Standard SMA.
  • Duly polished fiber at both end for Numerical Aperture Measurement.
  • Step indexed multimode PMMA plastic cable.
  • Numerical aperture Better than 0.5.
  • Acceptance Angle Better than 60
  • Fiber Diameter 1000 microns.
  • Outer Diameter 2.2mm.
  • Fiber Length 1m and 3m
  • In-Built Power Supply +5V/1.5A, ±12V/250mA.

Salient Features :

  1. 660nm and 950nm Transmitter.
  2. Two Nos. Of Photo Detector.
  3. On-board Sine & Square wave generator:10Hz-10KHz
  4. On-board 4th Order Low Pass Filer. 2 Nos
  5. In-Built DC Regulated Power Supply
  6. Front Panel Built With High Class Insulated Printed Circuit Board Sheet With Well Printed Circuits And Symbols
  7. Fuse For Short Circuit Protection
  8. Instruction Manual
  9. Connections are brought out through 2mm Brass Sockets.
  10. Patch Cords 2mm.
  11. The trainer is housed in ABS Plastic cabinet.
  12. Size of the trainer set 12”x10”


Optional accessories :

  • CRO
  • Optical Power Meter
  • Fiber Length 5m and 10m

Enquiry Form