Electronic Circuit Lab

Order Code: 19204644.2

Category: General Lab Equipment III

The trainer should have a main experiment unit with the below components: DC Power Supply Fixed DC power supply: Voltage 5V, 12V ; Max. current output 0.3A; wth output overload protection Dual DC power supply: Voltage range 3V~ 18V, continuo...



SPECIFICATION

The trainer should have a main experiment unit with the below components:
DC Power Supply

  • Fixed DC power supply: Voltage 5V, 12V ; Max. current output 0.3A; wth output overload protection
  • Dual DC power supply: Voltage range 3V~ 18V, continuously adjustable 1A ; Max. current  utput 1A ; With output overload protection

AC Power Supply

  • Voltage range 9V~0V~9V ; Max. current output 500 m A ; With output overload protection

Function Generator

  • Output waveform Sine triangle, square Output frequency 10~100KHz/4 settings ; Accuracy : ±5% of full scale value Output impedance : 50Ω ; output voltage : 18Vp-p (open loop) 9Vp-p (with 50Ω load 3 1/2 digital voltmeter/ammeter
  • DC voltage range 2V 200V DC current range 200μA 2000mA

Analog Meters

  • AC current : 0 ~ 100mA ~ 1A
  • AC voltage : 0 ~ 15V
  • DC current : 0 ~ 100mA ~ 1A
  • DC voltage : 0 ~ 20V
  • one 8Ω, 0.25W speaker with driver circuit
  • Variable Resistors
  • 1KΩ, 0.25W variable resistor with 3 terminals (A,B,C)
  • 10KΩ, 0.25W variable resistor with 3 terminals (A,B,C)
  • 100KΩ, 0.25W variable resistor with 3 terminals (A,B,C)
  • 1MΩ, 0.25W variable resistor with 3 terminals (A,B,C)
  • Breadboard
  • 1680 tie-point breadboard on top panel that can be easily put into and taken off Experimental modules 17 experiments modules secured in a solid – body plastic housing. each module to be equipped with an 8-bit DIP switch for circuits fault simulations.
  • Comprehensive experiment manual and instructor’s manual. The trainer modules should be as follows:
  • Diode, Clipper and Clamper Module
  • Rectifier, Differential & Integrator Circuits
  • Transistor Amplification Circuits
  • Multistage Amplification Circuits
  • OTL Amplifier Circuit
  • OCL Amplifier & Feedback Circuit
  • Two Oscillator Circuit Modules Voltage Regulator Circuits Voltage Regulator & Amplitude Modulation (AM) Circuits Frequency Modulation (FM) & OP Amplifier Circuits
  • Five OP-Amp Circuits modules 11 Experiments modules, each module to be equipped with an 8-bit DIP switch for circuits fault simulations.
  • Basic Electricity Experiments Module
  • Magnetism Element Introduction Module
  • Magnetic Field Module
  • Ampere’s Rule Module
  • Fleming’s Rule Module
  • Electromagnetic Induction
  • Electronic Circuit Fundamental Experiments Module
  • Two Basic Electronic Circuit Experiments
  • Special Electronic Components Experiments Module
  • Oscillator Experiments and Applications Module

 

  • Trainer Experiments List
  • Experiments for Basic Electricity: DC voltage measurement, Using an ohmmeter, Resistor characterisitics, DC current measurement, Ohm’s law, Power in DC circuit, Kirchoff’s law, Maximum power transfer theorem, DC RC circuit and transient phenomena, AC voltage/Current measurement, AC RC,RL,RLC Circuits, Transformer
  • characteristics, Series-resonant circuit,
  • Parallel-resonant circuit, LC filter
  • Experiments for Magnetism: Magnetic device/fields/curves/field strength,
  • Lenz’s & Faraday’s Law, Ampere’s & Flemming’s Rule, Self & Mutual
  • Induction, Magnetic Flux Detection
  • Experiments for Basic Electronic Circuits: Diode Characteristics, Rectifier/Filter Circuits, Zener/LED/Diode/FET/SCR/UJT Characteristics, Multimeter Functions
  • Experiments for Simple Electronic Circuits: Simple/Complimentary Amplifier, Voltage Regulator, Push-pull Amplifier, Wheatstone Bridge, Dimmer Circuit, Multistage cascading amplifier, Relay characteristics, Touch-controlled switch
  • Experiments for Industrial Control Applications: CDS Characteristics, Light-controlled circuit, Thermistor Characteristics, Temp-controlled circuits,Sound-controlled circuit
  • Experiments for Oscillator Characteristics and Applications: Blocking Oscillator, Electronic Birdcall Circuit, Astable Multivibrator, LED flasher circuit, LC resonant circuit
  • Experiments List
  • Characteristics of Diodes: Silicon, Germanium, Zener, LED & Optical Diodes
  • Clipping and Clamping Circuits with Diodes
  • Rectifier Circuits
  • Differential and Integrator Circuits
  • Transistors: PNP transistor, NPN transistor
  • Transistor Amplification Circuits
  • Field Effect Transistors (FET)
  • FET Amplification Circuits
  • Multi - Stage Amplification Circuits
  • Transistor Negative Feedback Circuits
  • Transistor Positive Feedback Circuits
  • Regulated Voltage /Constant Current Circuits
  • Modulation and Demodulation
  • OP-amps
  • Basic Characteristics of OP Amplifier
  • Basic Characteristics of OP Amplifier(1)- Negative Feedback
  • Basic Characteristics of OP Amplifier(2)-Negative Feedback
  • Basic Characteristics of OP Amplifier -Positive Feedback

Enquiry Form