The training system enables the trainee to use original parts for industrial applications. All components comply with the relevant DIN regulations. The system includes a test and fault simulator according to IEC/VDE standards. Action-oriented teaching materials support the trainer and trainees in the training of content concerning electrical safety, which contain at least the following learning materials: 
- Training board with industrial components; the boards can be mounted in a holding frame on the laboratory bench (see item Laboratory table).
The system should be supplied with a power supply of at least: a 400V three-phase supply, voltage: 400V three-phase supply, frequency: 50 Hz, current: 16 A, connected via 3P and earth contact socket. 
Protection class: l
The electrical mains must be equipped with an RCD (Residual Current Device) with a sensitivity of 30 mA or less. The technical characteristics of the built-in components should be as follows:
- Insulation control
- Three-phase star-delta transformer
- Protective circuits VDE 0100 (including RCD)
- Protection against direct and indirect contact
- Protection by safety extra-low voltage
- Residual current protective devices for earth-leakage circuit breakers
- Summation current transformer
- Protective measures in TN, TT and IT networks
- Ground resistance measurement
- Protective insulation and separation
- Grounding
- Safety measurement with industrial measuring instruments for protective measures
- Measurement protocol for determining the electrical safety of a system
- Electric installation testing board
- Universal testing device for all tests of the effectiveness of protective measures in electrical systems
- The Teachware contains exercises and descriptions for all content mentioned here (table of contents and example task attached to the offer).