Features

• Provision for Analog input, TTL input and RS-232 input
• Display to indicate forward voltage across and forward current flowing through LASER source
• Voltage and current is varies using intensity controle potentiometer
• Built in pulse generator with pulse widths of 30ns and 100ns
• All Connectors are suitable for ST type of connector interface

Laser Driver Circuit

• Digital and Continuous Wave Driver Circuits
• Two driver modes are available in this system, one for pulse operation and analog transmission, other for continuous wave operation and Digital Transmission
• These are controlled by rotary switch available on front panel.

Photodetector Circuit

• Photodetector produces current in response to optical input.
• This current produced is then converted to voltage and amplified by amplifier.
• This amplified output is measured as electrical output

 
Specifications

• Provision for analog input, TTL input and RS-232input
• Displays to indicate forward voltage across and forward current flowing through LED source
• Voltage and current is varied using intensity control potentiometer

Source - 1

• Type    : LASER
• Central Wavelength    : 1310nm
• Spectral Width    : 2nm
• Output Power    : 0.8mW
• Threshold Current    : 5mA

Source - 2

• Type    : LASER
• Central Wavelength    : 1550nm
• Spectral Width    : 1nm
• Output Power    : 0.9mW
• Threshold Current    : 5mA

Detector - 1

• Type    : PIN photo diode
• Spectral Bandwidth    : 1250nm ~ 1600nm
• Responsivity    : 0.8 A /W
• Bandwidth    : 1.5 GHz

Detector - 2

• Type    : PIN TIA photo diode
• Spectral Bandwidth    : 1150 ~ 1600nm
• Sensitivity    : -37dbm
• Signal Bandwidth    : 155 MHz
• Date Rate    : 155 Mbps

Pulse Generator

• Pulse Width    : Selectable from 30ns and100ns
• 30ns Pulse Amplitude    : 3V
• 100ns Pulse Amplitude      : 4V

Accessories

• ST-ST Patch Cord - 1mtr    : 07 No.
• Power Cord    : 01 No.
• BNC-BNC Cable    : 03 No.
• BNC-BNC ‘T’ Conn.    : 01 No.
• RS232 Cable    : 02 No.