Determination of Y by bending of a beam using Koenig’s method (C.R.)

Order Code: 55807

Category: Physics Trainers

  55807 Experimental Set-Up has been designed specifically to determine Y by bending of a beam using Koenig’s method. The set up consists of bending of bar apparatus, Diode laser, two stands, translucent scale etc. The set-up is comp...



SPECIFICATION

 
55807 Experimental Set-Up has been designed specifically to determine Y by bending of a beam using Koenig’s method. The set up consists of bending of bar apparatus, Diode laser, two stands, translucent scale etc.
The set-up is complete in all respects and requires no other apparatus. Practical experience on this set up carries great educative value for Science and Engineering Students.
 
OBJECT
  1. To determine Y by bending of a beam using Koenig’s method.
 
FEATURES
The complete Experimental Set-up consists of the followings :
  1. Bending of Bar Apparatus : It consists of a brass beam 1 cm square and 1 metre long supported horizontally on two knife edges fixed  sturdy cast iron table clamps. It carries a hanger at its mid point for loading. Two tilting and adjustable plane mirrors are attached almost normally to the beam near its ends facing each other. Without weights.
  2. Diode Laser with Power Supply.
    • Maximum output : 0.5 mW
    • Wave length : 670 nm visible red
    • Power supply : Included with ON/OFF switch working on 230V mains.
  3. Two stands : One for Diode Laser and other for translucent scale
  4. Translucent scale : 50cm.
  5. Slotted weights : With hanger 0.5kg sets of five including hanger.
  6. Strongly supported by detailed Operating Instructions, giving details of Object, Theory, Design procedures, Report Suggestions and Book References.

Enquiry Form