Arduino Robot

Order Code: 19203472.19

Category: General Lab Equipment III

Arduino Robo; Control board = Microcontroller=ATmega32u4, Operating Voltage=5V, Input Voltage=5V through flat cable, Digital I/O Pins = 5, PWM Channels = 6 Analog Input Channels=4 (of the Digital I/O pins), Analog Input Channels (mul...



SPECIFICATION

  • Arduino Robo;
  • Control board = Microcontroller=ATmega32u4,
  • Operating Voltage=5V,
  • Input Voltage=5V through flat cable,
  • Digital I/O Pins = 5,
  • PWM Channels = 6
  • Analog Input Channels=4 (of the Digital I/O pins),
  • Analog Input Channels (multiplexed) = 8,
  • DC Current per I/O Pin=40 mA,
  • Flash Memory=32 KB (ATmega32u4) of which 4 KB used by bootloader,
  • SRAM=2.5 KB (ATmega32u4),
  • EEPROM (internal)=1 KB (ATmega32u4),
  • EEPROM (external)=512 Kbit (I2C),
  • Clock Speed=16 MHz,
  • Keypad=5 keys,
  • Knob=potentiomenter attached to analog pin,
  • Full color LCD=over SPI communication,
  • SD card reader=for FAT16 formatted cards,
  • Speaker=8 Ohm,
  • Digital Compass=provides deviation from the geographical north in degrees,
  • I2C soldering ports=3,
  • Prototyping areas=4,
  • Radius=185 mm,
  • Heigth=85 mm;
  • Motor board = MicrocontrollerD164:
  • D180=ATmega32u4,
  • Operating Voltage=5v,
  • Input Voltage=9V to battery charger,
  • AA battery slot=4 alkaline or NiMh rechargeable batteries,
  • Digital I/O Pins=4,
  • PWM Channels=1,
  • Analog Input Channles=4 (same as the Digital I/O pins),
  • DC Current per I/O Pin=40 mA,
  • DC-DC converter=generates 5V to power up the whole robot,
  • Flash Memory=32 KB (ATmega32u4) of which 4 KB used by bootloader,
  • SRAM=2.5 KB (ATmega32u4),
  • EEPROM=1 KB (ATmega32u4) Clock  Speed=16 MHz,
  • Trimmer=for movement calibration,
  • IR line following sensors=5,
  • I2C soldering ports=1,
  • Prototyping areas =2;

Enquiry Form