Analog & Digital Training System

Order Code: 22235758.4

Category: General Lab Equipment II

High level, high quality digital-analog trainer Replaceable 4 pin connector, easy to maintenance Combines all essential function of analog and digital experiment With removable breadboard, DC power supply, function generator, two pulse switc...



SPECIFICATION

  • High level, high quality digital-analog trainer
  • Replaceable 4 pin connector, easy to maintenance
  • Combines all essential function of analog and digital experiment
  • With removable breadboard, DC power supply, function generator, two pulse switches, 2 1/2 inch 8 ohm 0.5W speaker and etc

Technical

SOLDERLESS BREADBOARD:

  • Interconnected with 2820 tie points nickel plated contact, fitted all DIP sizes and all components with lead and solid wire AWG # 22-30 (0.3-0.8mm).
  • It can be changed and replaced for different purpose and can be connected with demonstration panel.
  • Therefore, it is very convenient for both teachers and students.

DC POWER SUPPLY:

  • Fixed DC output +5V, 1A
  • Fixed DC output -5V, 1 A
  • Variable DC output 0V to +15V, 1 A.
  • Variable DC output 0V to 15V, 1 A.

POTENTIOMETERS:

  • Variable resistor VR1 = 1k
  • Variable resistor VR2 = 100k

FUNCTION GENERATOR:-

  • Frequency range: 1Hz 10Hz, 10Hz 100Hz, 100Hz 1kHz, 1kHz 10kHz, 10kHz 100kHz
  • Amplitude : Sine wave output 0 10 Vpp variable

       Triangle wave output 0 10 Vpp variable
       Square wave output 0 10 Vpp variable
       TTL mode output 4 Vpp

SIXTEEN BITS DATA SWITCHES:

  • 16pcs toggle switches and corresponding output point.
  • When switch is set at down position,the output is LO level; contrarily, it is to be HI level while setting at up position.

TWO PULSE SWITCH:

  • (WITH 2 SET OF OUTPUT: (A , A ,B , B)) 2pcs pushbuttons contain switches debouncer for eliminating the bounce caused by switch from open to close or from close to open position.

SPEAKER:

  • 2-1/2 inch diameter, 8 ohm/0.5W to be used for load.

FOUR CHANNEL ADAPTOR:

  • Both of the two banana sockets' and two BNC jacks' point tips are changeable. It is suitable for to be connected with peripherals.

TWO DIGITS OF 7 SEGMENT LED DISPLAY:

  • Output display Numerical designs and resultant displays

SIXTEEN BITS LED DISPLAY:

  • 16 red LED's separate input terminals. The LED will be lighted up when input is at HI level ,and it will be turned off when it is at no input or at LO level .

OTHER STANDARD ACCESSORIES:

  • Power cord
  • Pin: 10cm 20pcs/20cm 20pcs
  • User manual

INPUT VOLTAGE:-

  • 110~127VAC 10% 60Hz, 220~240 10% 50Hz Switchable

Enquiry Form