4.0 t, electro-hydraulic, symmetrical, runway length 5100 mm, with wheel-free jack and wheel alignment, surface mounting.
 Technical description: 

• Hydraulic cylinder located in fixed guide rail for complete protection 

• High-strength, galvanized and pre-stretched lifting cables

• Large diameter sheaves with self-lubricating and maintenance-free bushes 

• Mechanical support devices (every 100 mm in the lifting run) with automatic engagement and pneumatic release, allowing work to be carried out in a stationary position with the cables unloaded.

• Rope breakage protection

• Acoustic squeeze warning signal with automatic release in the lower part of the lowering movement

• Mechanical, electrical and hydraulic safety devices in compliance with current regulations for CE marking

• Low voltage control circuit (24 V)

• Extra-long aisles for complete wheel alignment, with recesses for turntables at the front and swing plates at the rear

• Electro-hydraulic wheel-free lift integrated in the rails, with adjustable and hydraulic synchronization of the lifting and lowering movement.

• The axle lifts, completed by the wheel-free jacks, are the optimal solution for the complete inspection of vehicle axles.

Technical dimensions: 

• Load capacity: 4,000 kg 

• Max. lifting height: 1,985 mm

• RFH load capacity: 3,500 kg 

• Lifting height RFH max.: 395 mm 

• Drive-on / drive-over height: 230 mm 

• Runway length: 5,100 mm 

• Runway width: 650 mm 

• Distance between rails: 825 1,175 mm 

• Column spacing: 2,800 mm

• Drive-through width: 2,470 mm 

• Installation area L x W x H: 6,400 x 3,155 x 2,614 mm